Lockdown And Custom Serialization
- JupyterLab >= 3.0
To install the extension, execute:
pip install webds_lockdown_and_custom_serialization
To remove the extension, execute:
pip uninstall webds_lockdown_and_custom_serialization
Note: You will need NodeJS to build the extension package.
The jlpm
command is JupyterLab's pinned version of
yarn that is installed with JupyterLab. You may use
yarn
or npm
in lieu of jlpm
below.
# Clone the repo to your local environment
# Change directory to the webds_lockdown_and_custom_serialization directory
# Install package in development mode
pip install -e .
# Link your development version of the extension with JupyterLab
jupyter labextension develop . --overwrite
# Rebuild extension Typescript source after making changes
jlpm build
You can watch the source directory and run JupyterLab at the same time in different terminals to watch for changes in the extension's source and automatically rebuild the extension.
# Watch the source directory in one terminal, automatically rebuilding when needed
jlpm watch
# Run JupyterLab in another terminal
jupyter lab
With the watch command running, every saved change will immediately be built locally and available in your running JupyterLab. Refresh JupyterLab to load the change in your browser (you may need to wait several seconds for the extension to be rebuilt).
By default, the jlpm build
command generates the source maps for this extension to make it easier to debug using the browser dev tools. To also generate source maps for the JupyterLab core extensions, you can run the following command:
jupyter lab build --minimize=False
pip uninstall webds_lockdown_and_custom_serialization
In development mode, you will also need to remove the symlink created by jupyter labextension develop
command. To find its location, you can run jupyter labextension list
to figure out where the labextensions
folder is located. Then you can remove the symlink named @webds/lockdown_and_custom_serialization
within that folder.
See RELEASE