This is an example of Artificial Intelligence (AI) calculations on a very cheap hardware.
Details on function, installation and configuration can be found on the Wiki Page
A 3d-printable housing can be found here: https://www.thingiverse.com/thing:4571627
If you would like to support the developer with a cup of coffee you can do that via Paypal.
- slow response of web server during picture analysis
- spontaneous reboots (mostly due to html access during image processing) - self recovery implemented
General remark: Beside the firmware.bin
, typically also the content of /html
needs to be updated!
- Upgrade digital CNN to v8.2.0 (added new type of digits)
- Supporting alignment structures in ROI definition
- Bug fixing: definition of hostname in
config.ini
- Additional alignment marks for settings the ROIs (analog and digit)
- Upgrade analog CNN to v7.0.0 (added new type of pointer)
- NEW: 6.3.1: bug fixing in initial edit reference image and
config.ini
(Spelling error inInitialRotate
) - Initial setup mode: bug fixing, error correction
- Bug-fixing
-
NEW 6.2.2: bug fixing
-
NEW 6.2.1: Changed brightness and contrast to default if not enabled (resolves to bright images)
-
Determination of fixed illumination settings during startup - speed up of 5s in each run
-
Update digital CNN to v8.1.1 (additional digital images trained)
-
Extended error message in MQTT error message
-
Image brightness is now adjustable
-
Bug fixing: minor topics
- Disabling of analog / digital counters in configuration
- Improved Alignment Algorithm (
AlignmentAlgo
=Default
,Accurate
,Fast
) - Analog counters:
ExtendedResolution
(last digit is extended by sub comma value of CNN) config.ini
: additional parameterhostname
(additional to wlan.ini)- Switching of GPIO12/13 via http-interface:
/GPIO?GPIO=12&Status=high/low
- Bug fixing: html configuration page, wlan password ("=" now possible)
-
Major change: image processing fully in memory - no need of SD card buffer anymore
- Need to limit camera resolution to VGA (due to memory limits)
-
MQTT: Last Will Testament (LWT) implemented: "connection lost" in case of connection lost to
TopicError
-
Disabled
CheckDigitIncreaseConsistency
in default configuration - must now be explicit enabled if needed -
Update digital CNN to v7.2.1 (additional digital images trained)
-
Setting of arbitrary time server in
config.ini
-
Option for fixed IP-, DNS-Settings in
wlan.ini
-
Increased stability (internal image and camera handling)
-
Bug fixing: edit digits, handling PreValue, html-bugs
There are some ideas and feature request, which are not followed currently - mainly due to capacity reasons on side of the developer. They are collected here: FeatureRequest.md
- n.a.