based on the latest SX1301 driver lora_gateway v5.0.1 and semtech packet_forwarder v4.0.1

Note: This project is only used for USB interface of RAK833 + Raspberry Pi, if you want to use SPI interface of RAK833 + Raspberry Pi, please use this project: https://github.com/RAKWireless/RAK2245-RAK831-LoRaGateway-RPi-Raspbian-OS. But you should notice the reset GPIO pin definition which is the value of SX1301_RESET_BCM_PIN macro in the start.sh file, it is pin17 now, and you can modify this value according to your hardware.

This project currently provides support for the below platforms.

• RAK833/RAK2247

2019-06-18 RAK V2.8

• 1.Add eth0 config
• 2.After the network is disconnected, lora_pkt_fwd restarts
• 3.Modify loraserver.toml for us915 and cn 470
• 4.Streamlined local_conf.json files

2019-05-06 RAK V2.1R

• Add loraserver
• Add AP mode

step1 : Download and install Raspbian Stretch LITE

step2 : Clone the installer and start the installation

  $ git clone https://github.com/RAKWireless/RAK833-LoRaGateway-RPi.git ~/rak833-loragateway
  $ cd ~/rak833-loragateway
  $ sudo ./install.sh

step3 : Now you have a running gateway after restart! in additon you can check the log info at /var/log/syslog.