I've noticed a few times that when powering on the SID, it seems to loop the boot sequence, where all LEDs light up before falling down and starting the pattern - it will simply repeat all LEDs lighting up over and over. Whenever this happens a power cycle solves the issue. It's powered via the 5v on the ESP32.
Would be nice to be able to adjust the Brightness without the use of the remote, either via the Config Portal or TCD Commands over BTTFN - or both.
Additionally maybe be able to adjust each color separately for different levels (much like the TCD), as I find the yellow and red to be more intense than the green.
If "follow TCD night-mode" and "show clock when screen saver is active", then show the clock with dimmer light level - much like the display on the TCD can be dimmed?
Full/Normal Brightness with "show clock when Screen Saver is active" while the TCD is not in night-mode, or the option to follow the TCD night-mode is not selected.
Over the past few days I've noticed that the SID is losing all its settings when powered off/on - it is intermittent and doesn't seem to happen every time. The PSU is 12V/5A, and the SID has had daily use. Anything to check?