6.1.0 (possibly) breaks AutoRCM about reinx HOT 9 CLOSED

Because they're probably enabling and disabling again.. just do it once. All autorcm does is write to the RSA mod on the BCT in nand. It literally bricks your nand forcing the system into RCM mode. lol

from reinx.

Same problem here

from reinx.

Updating the firmware at all ever will write a new firmware to the respective partitions, which overwrites the autorcm modification. That's always been a thing. So all you have to do is re-enable it.

from reinx.

OP said disabling/re-enabling doesn't work.

from reinx.

Because they're probably enabling and disabling again.. just do it once. All autorcm does is write to the RSA mod on the BCT in nand. It literally bricks your nand forcing the system into RCM mode. lol

This works, wasn't paying enough attention when i did this the first time i guess.
Thanks for your help.

from reinx.

Great stuff

from reinx.

Having this issue again, switch is essentially in "bricked state" after disable/reenable but is recognized as Nintendo Switch rather than 'APX'. Any ideas?

from reinx.

uhh try fully powering it off (holding power for 20 seconds) and turn it on?

from reinx.

uhh try fully powering it off (holding power for 20 seconds) and turn it on?

that works, but i have to do this every time i turn the console off now. eh, i'll just deal with it i guess.

from reinx.