Any support for the PatPet commander? I'm trying to do a couple of things.

1.) have a microphone that detects when loud noise comes (like a bark)
2.) Trigger just the audio tone or vibrate, not the shock if it detects an even like that.
3.) Ability to remotely shut it down (was thinking running it on a raspberry pi or something like that

Then I can manually log into my camera system to check in on the pet and this helps automate some training, remotely.

The project logo should be re-created as scalable vector graphics.

• Höhere Level mit mehreren Tasten
• Ranking
• Shock-Erhöhung nach Fehler
• ggf. Shock-Reduzierung nach Zeit
• Memory-Modus
• +5 Schalter

The only printed code on a 300M/600M (NCP) is 6 digits. The remoshock config file does not accept this and the code refers to a 2 digit decimal code. I alternatively tried to get the '12 bit' code from my transmitter but I have issues getting the proper binary output in URH from my HackRF (very new at SDR's) I can capture and replay commands are picked up by the collar so the RF and antenna are working. I just can't get the output to match the things like prefix and intensity strings.

Alternatively pairing a new transmitter requires the intensity set to 0 and the nick and continuous buttons pressed together for ~2-3 seconds. It's not as simple like one of the 433Mhz's ones that just require a random button press to pair.