Problem with installation of library (OpenCM) for Arduino about opencm9.04 HOT 5 CLOSED

Hi, @GrigoriyAY

Would you like to try again with the instructions below?

• E-manual

from opencm9.04.

I used this manual. I think the problem is in the Arduino IDE. When I try to update libraries via Library Manager, I get the following message:

java.lang.RuntimeException: java.lang.Exception: При обновлении списка библиотек возникла ошибка! at cc.arduino.contributions.libraries.ui.LibraryManagerUI.lambda$onUpdatePressed$2(LibraryManagerUI.java:206) at java.lang.Thread.run(Thread.java:748)
Caused by: java.lang.Exception: При обновлении списка библиотек возникла ошибка! at cc.arduino.contributions.libraries.LibraryInstaller.updateIndex(LibraryInstaller.java:80)
at cc.arduino.contributions.libraries.ui.LibraryManagerUI.lambda$onUpdatePressed$2(LibraryManagerUI.java:202)
... 1 more <

Could you suggest how to manually place the library for OpenCM in the necessary folders?

from opencm9.04.

@GrigoriyAY

Sorry for my late reply.

Could you suggest how to manually place the library for OpenCM in the necessary folders?
I think there was something about this in the Arduino official document, but I can not find it now...

As an alternative, please refer to the link below.

• HOWTO : Adding multiple OpenCR boards to the Arduino IDE

In this case, it is necessary to set things related to tools separately, but there is no official guide related to this.

from opencm9.04.

This issue will be closed since there were no actions for a while. You can reopen this issue to show this issue to the users whenever. Thanks.

from opencm9.04.

@OpusK
Thank you, it works!

from opencm9.04.