shmick / triumph-canbus-gearinfo Goto Github PK

Hello;

Not an issue at all, but I came across your github while looking for info about the Triumph canbus.

I have the clocks removed and are away from my bike (Tiger 1050) so I cannot sniff the bus myself.

While the gauges power up normally using a bench supply, and display most just info, on the Tiger there's 2 LCDs, one that shows stats info such as clock/time, litres / 100km as well as Fuel levels and Temperature level bars, this one is functioning correctly.

The other shows the speed in 3 large digits and the odometer / trip at the bottom in small digits, and although the odometer mileage is shown, there are no large digits displayed, not even zero.

I now suspect that when the ignition is switched on, the ECU sends a one-time init command to the dashboard, and I was wondering if you had any sniffed data from your bike, specifically when the ignition is first switched on, I suspect this might be a one-time message that the gauges use to initialise.

I am aware and able to call the 0x540 (LEDS & GEARS), 0x550 (TEMP/FUEL) , 0x518 (RPM) and 0x519 (SPEED) but are unable to for example switch between KM/MILES using a 3 button press that when fitted to the bike can be done.

Would be great if you were able to share any canbus dumps that you have, I know all bikes / models / years will be slightly different, but I think that the address and bytes sent are very similar across all models.

Cheers

PeterC