silver13 / cg023 Goto Github PK

Hello,

I flashed the CG023 port onto my blue board H8 mini. Everything went as expected (mislabeled DAT/CLK; had to replug battery after erasing).

But now after powering the H8 up, the front left motor is spinning up in a pattern like a flashing led would do (4 times spinning up, short pause, repeat).

The flashing itself went successfully and exactly like described, so i guess I maybe have a board version with different wiring were pin layout is not the same.

I bought the H8 from banggood in Aug 2016 and it has a blue board. Sadly I glued a camera directly ontop of the board so I can't follow the pins from the microcontroller myself and configure it in hardware.h.

Might this be suitable/feasible to flash to Syma X5SC/X5SC-1 type quadcopters?
That'd be the dream come true for flying acro mode on a cheap medium sized toy drone

Hi, would it be possible to completely ditch the onboard RX(BK2425), stock remote controller, and use NRF24l01+ as RX and NRF24l01+ with arduino as remote controller ?
How would I approach this ?
SOC: STM F032K6
MPU: 6050A