1. Is 'Revised by:' and 'reviser name' included? [NO]
   comment: Kade didn't want his name on this, that's okay i guess

2. Do all VCC connections use the VCC symbol (oriented upward)? [NO]
   comment: 3.3V net off of JP11 should be a supply symbol

3. Does every part have a NAME and VALUE (with proper prefix and no '$')? [NO]
   comment: USBAB connector should be a "JP"

4. Are vias tented correctly? [YES]
   comment: Yes, but the bstop by the jumpers needs to be scooted over the jumper traces (or removed)

5. Is the LED color standard followed? (red for power, blue for STAT, green for TX, yellow for RX) [NO]
   comment: TX LED should be green, RX led should be yellow

6. Are any traces exposed? [YES]
   comment: Strange bstop near jumpers, also mentioned in via/stop check issue

7. Is the designer name included in tDocu? [YES]
   comment: jim lidblom is overlapping the designed by text

The new version has staking vias in the gnd pads.

Looks like R3, R4 and JP1 have different prod ids than what I'm seeing in sparkle. Could you please check this out, and make it all consistent. Thanks!

-Design by
-Rev by
-Version number
-SparkFun logo needs to be updated to a new part
-update to new CC-4.0 frame.

1. Is there a correct version number in the copper? [YES]
   comment: Yes, but would you please slide it to the board edge and thanks

2. Are measurements included for outer dimension and standoffs (Eagle layer 47)? [YES]
   comment: Way to go remembering to update measures rock on

3. Please shift board so that the bottom left of the dimension is at 0,0. Thanks!