Is there a SparkFun Logo? [NO]
comment: sparkfun logo needs to be updated so it uses the logo graphic (not just the letters 'SFE')

Is there an OSHW logo? [NO]
comment: no OSHW in sch

Is proper attribution given to the original designer? [NO]
comment: needs designer

Is 'Revised by:' and 'reviser name' included? [NO]
comment: needs revised by and revisor

Have all nets been drawn straight out from pin connections at least one grid space? [NO]
comment: RF GND off of the antennae needs some space

Is the VCC range clearly labeled? [NO]
comment: needs vcc range in sch

Are any jumpers labeled clearly by their function and possible settings? [NO]
comment: could use a note saying 'close jumper to enter low power mode'

Does every part have a NAME and VALUE (with proper prefix and no '$')? [NO]
comment: U2 should be a L, and it needs to be rotated 180, the nets are overlapping, JP4 and JP5 should be an SJ - also needs to be updated to new jumper device

Does every part have a PROD_ID? [NO]
comment: check your prod ids, theres a few missing

Do any parts have unnecessary values (Eagle has autoset the package as the value)? [YES]
comment: U3

Is the LED color standard followed? (red for power, blue for STAT, green for TX, yellow for RX) [NO]
comment: LED should be blue

Are measurements included for outer dimension and standoffs (Eagle layer 47)? [NO]
comment: needs measures

Is the designer name included in tDocu? [NO]
comment: needs designer name

Is 'Revised by:' and 'Revisor Name' included in tDocu? [NO]
comment: needs this