Processing is an open-source development environment and programming language, designed for learning how to code. While it's very flexible and powerful, it's mainly used in the realm of visual arts. This guide will help you get started with it.

As well as a Raspberry Pi with an SD card loaded with Raspbian, you'll also need:

The following hardware is required to work through the second worksheet.

• 1 x Solderless breadboard
• 1 x Tactile button
• 1 x LED
• 1 x 330 ohm resistor
• 4 x Male-to-female jumper leads

You will need the following worksheets to get started:

• The worksheet
• The second worksheet

These worksheets are just a starting point. To learn more, browse the selection of tutorials on Processing.org.

Unless otherwise specified, everything in this repository is covered by the following licence:

Introduction to Processing by the Raspberry Pi Foundation is licensed under a Creative Commons Attribution 4.0 International Licence.

Based on a work at https://github.com/raspberrypilearning/introduction-to-processing