Crash when open some GRBL settings about iosender HOT 3 CLOSED

Try the latest edge version.

FYI to enable lathe mode in the controller set $32=2, this unlocks some lathe specific gcodes.

from iosender.

Bug present in in this version: https://github.com/terjeio/ioSender/releases/tag/2.0.42
Looks like bug doesn't exist in ioSender XL Edge 2.0.43p1.zip
May be it time to make another release?

By the way - "Parting" is grayed out after startup. After press once jog control X+ or X- it become available. Is there a reason or is it another bug?

Another question: is there any RPM window that show actual RPM from encoder? It may be useful not only during use, but for test encoder also. If there none, I suggest to add it below(or above) DRO area if possible.

from iosender.

May be it time to make another release?

The edge versions are prereleases - I'll add the changes in the next full release.

By the way - "Parting" is grayed out after startup. After press once jog control X+ or X- it become available. Is there a reason or is it another bug?

It is another bug - fixed in the latest edge versions.

Another question: is there any RPM window that show actual RPM from encoder?

No. However, when actual RPM is available it is shown in the current RPM field (instead of the programmed speed).

from iosender.