(Placeholder)

Software Required (On Local system)

• Arduino IDE

Libraries that are required:

• Adafruit_GFX (Graphics Driver)
• Adafruit_SSD1306 (LCD Driver)

• serialdbgspeed = Set the serial debug speed
• bbgrams = Set the Nerf dart weight (or BB) weight in grams for joules calculation.

• ERR1 = Couldn't Read
• ERR2 = Too Fast; Readable limit is 420 feet per second.

• Reset by holding gate #1
• Readout in Joules
• Readout for average Joules

• Use different splash screen instead of the Adafruit default splash screen.

• The gate[I/O pin]pin are pins that the sensors that are connected to. If you are using the Open Chrony V4 board from @legodei, you don't need to change these #defines.
• gatedistance is the distance between the gates.
• SCREEN_WIDTH/SCREEN_HEIGHT/OLED_RESET don't need to be changed. These #defines corrospond to an SSD1306 OLED on the I2C bus.