For initial set-up, you'll need a serial or SSH connection to the Controller in your EasyMesh network (for running ubus commands.)

• The controller in the prplMesh network must have lighttpd and amx-fcgi built/deployed.
• The port that the controller will listen for HTTP requests on is configurable in the lighttpd.conf file, located at /etc/lighttpd/lighttpd.conf
  • Change the port via the server.port = <int> entry. Defaults to 8080.
• Configure the firewall on the Controller to permit incoming HTTP traffic on the port you want, or just do iptables -P INPUT ACCEPT

To test whether or not the HTTP<->Ambiorix proxy is running, and the port is open, do:

curl -u username:pass "http://<controller_ip>:<controller_port>/serviceElements/Device."

You'll additionally need some external packages:

sudo apt install graphviz

python -m venv ./

source ./bin/activate

python -m pip install -r requirements.txt

python main.py

firefox localhost:8050 & disown

This user interface was used to demonstrate AP onboarding and manufacturer interoperability within the prplMesh ecosystem in this YouTube video

To reproduce this demo, follow the steps in DEMO.md

python tests.py