$ docker-compose -f srsgnb_zmq.yaml up && docker container attach srsgnb_zmq
WARNING: Found orphan containers (metrics, amf, hss, osmomsc, nrf, ausf, upf, osmohlr, webui, nssf, sgwc, smf, pcf, sgwu, udr, bsf, udm, pcrf, scp, mme, mongo) for this project. If you removed or renamed this service in your compose file, you can run this command with the --remove-orphans flag to clean it up.
Creating srsgnb_zmq ... done
Attaching to srsgnb_zmq
srsgnb_zmq | Configuring component: 'gnb_zmq'
srsgnb_zmq | * Starting system message bus dbus [ OK ]
srsgnb_zmq | avahi-daemon: unrecognized service
srsgnb_zmq | Deploying component: 'gnb_zmq'
srsgnb_zmq | --- Software Radio Systems LTE eNodeB ---
srsgnb_zmq |
srsgnb_zmq | Couldn't open , trying /root/.config/srsran/enb.conf
srsgnb_zmq | Couldn't open /root/.config/srsran/enb.conf either, trying /etc/srsran/enb.conf
srsgnb_zmq | Reading configuration file /etc/srsran/enb.conf...
srsgnb_zmq |
srsgnb_zmq | Built in Release mode using commit 10f81ca03 on branch lc/main.
srsgnb_zmq |
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | Opening 1 channels in RF device=zmq with args=fail_on_disconnect=true,tx_port=tcp://172.22.0.22:2000,rx_port=tcp://172.22.0.34:2001,id=enb,base_srate=23.04e6
srsgnb_zmq | Supported RF device list: UHD soapy zmq lime file
srsgnb_zmq | CHx base_srate=23.04e6
srsgnb_zmq | CHx id=enb
srsgnb_zmq | Current sample rate is 1.92 MHz with a base rate of 23.04 MHz (x12 decimation)
srsgnb_zmq | CH0 rx_port=tcp://172.22.0.34:2001
srsgnb_zmq | CH0 tx_port=tcp://172.22.0.22:2000
srsgnb_zmq | CH0 fail_on_disconnect=true
srsgnb_zmq |
srsgnb_zmq | ==== eNodeB started ===
srsgnb_zmq | Type <t> to view trace
srsgnb_zmq | Current sample rate is 11.52 MHz with a base rate of 23.04 MHz (x2 decimation)
srsgnb_zmq | Current sample rate is 11.52 MHz with a base rate of 23.04 MHz (x2 decimation)
srsgnb_zmq | Setting frequency: DL=1842.5 Mhz, DL_SSB=1842.05 Mhz (SSB-ARFCN=368410), UL=1747.5 MHz for cc_idx=0 nof_prb=52
t
srsgnb_zmq | RACH: slot=1931, cc=0, preamble=0, offset=0, temp_crnti=0x4601
srsgnb_zmq | Disconnecting rnti=0x4601.
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
srsgnb_zmq | connect(): Connection timed out
srsgnb_zmq | Failed to initiate NG connection. Attempting reconnection in 10 seconds
$ docker-compose -f srsue_5g_zmq.yaml up -d && docker attach srsue_5g_zmq
WARNING: Found orphan containers (hss, sgwu, udm, osmomsc, bsf, pcrf, scp, ausf, udr, upf, srsgnb_zmq, smf, webui, pcf, metrics, nrf, mme, nssf, mongo, amf, osmohlr, sgwc) for this project. If you removed or renamed this service in your compose file, you can run this command with the --remove-orphans flag to clean it up.
Creating srsue_5g_zmq ... done
Built in Release mode using commit 10f81ca03 on branch lc/main.
Opening 1 channels in RF device=zmq with args=tx_port=tcp://172.22.0.34:2001,rx_port=tcp://172.22.0.22:2000,id=ue,base_srate=23.04e6
Supported RF device list: UHD soapy zmq lime file
CHx base_srate=23.04e6
CHx id=ue
Current sample rate is 1.92 MHz with a base rate of 23.04 MHz (x12 decimation)
CH0 rx_port=tcp://172.22.0.22:2000
CH0 tx_port=tcp://172.22.0.34:2001
Current sample rate is 11.52 MHz with a base rate of 23.04 MHz (x2 decimation)
Current sample rate is 11.52 MHz with a base rate of 23.04 MHz (x2 decimation)
Waiting PHY to initialize ... done!
Attaching UE...
Random Access Transmission: prach_occasion=0, preamble_index=0, ra-rnti=0xf, tti=1931
Received RRC Reject
Random Access Complete. c-rnti=0x4601, ta=0
Awaiting for a response...