Vck 190 setup problems. about vitis-ai HOT 4 OPEN

@meltedhyperion The System Controller is a Zynq Ultrascale+ device on the VCK190 that does system and board level management. In other words, I believe you are trying to install the libraries and run the model on the System Controller ZU+ device.

The critical first step needs to be to establish a connection to UART0 (the first of the three emulated COM ports). UART0 communicates with the Versal target.

A few things to check:

[1] Did the System Controller boot successfully? Yes.
[2] Can you boot from QSPI and connect to UART0 when booting from QSPI?
[3] Is the SD Card for the Versal image faulty?
[4] Is there a problem with the VCK190 Vitis AI SD Card image file that was downloaded? Can you boot the board from an alternative VCK190 image such as this one: https://xilinx.github.io/vck190-base-trd/2022.1/html/run/run-setup.html

from vitis-ai.

@quentonh Yes that's what I was doing apparently, and that's the wrong approach, right?!
I tried connecting to UART0. I am using ubuntu on my host machine and it shows 4 Serial connections for VCK190 (ttyUSB0, ttyUSB1, ttyUSB2 and ttyUSB3 (where the System controller terminal is opening on USB3))
I tried all 4 and only USB3 responds by opening the emulated terminal for system controller (i am using picocom).

Do i need to flash an image on the Versal SD card as well? The SysCtrl SD card image comes with a pre flashed image, and the Versal one is empty

from vitis-ai.