Compiling erros about liorf HOT 5 CLOSED

Thanks for your advice!
I have fixed this bug, you can try it again.
I have tested with 18.04，but have not tested with 20.04 yet.
For more information, please refer to Issues #206

from liorf.

Hi, I will test it for you now then and report today, thanks by your fast response.

from liorf.

Just confirm you it will compile and work.
What I found, not sure if it is important for you, it wont appear as a ros pkg with roslaunch, is needed put manual the full address, in my case as follow.
roslaunch lio_sam_ws/src/liorf/launch/run_lio_sam_livox.launch

my other problem no related is how to setup the config file for livox avia and its internal imu, in my case probably the default data of noise and bias are not enough good by default, if by causality you use a Livox Avia too would be nice if you can share the setup

from liorf.

I got this graph, I don't know if it is possible extract the data from it.

in any case maybe helps someone, it is a BMI088

from liorf.

Just confirm you it will compile and work. What I found, not sure if it is important for you, it wont appear as a ros pkg with roslaunch, is needed put manual the full address, in my case as follow. roslaunch lio_sam_ws/src/liorf/launch/run_lio_sam_livox.launch

my other problem no related is how to setup the config file for livox avia and its internal imu, in my case probably the default data of noise and bias are not enough good by default, if by causality you use a Livox Avia too would be nice if you can share the setup

Sorry for the late reply！ For the built-in imu of livox, the noise parameters in my yaml are as follows:

  imuAccNoise: 0.00059
  imuGyrNoise: 0.000061
  imuAccBiasN: 0.000011
  imuGyrBiasN: 0.000001

By the way, liorf can not directly use Livox lidar for mapping. You need to use a specific driver(livox_ros_driver modified by TixiaoShan) or use a custom data conversion node.

from liorf.