yschroeder / face-shield Goto Github PK

Hi, I've been using your version without the text. I just realized that these are the EU/International version. Can you please modify the US version and upload that as well?

Thank you!!

S3D detects non manifold edges in the stacked versions. PrusaSlicer seems to work.

We should investigate this. Maybe the single models are not properly fused together?

I summon @jvanbalen 😃

Could you provide a version with standard 80-80-80 distance between the holders?
This would enable easy punching of a4 sheets with a common double-puncher.

For simple shields a total height of 11mm seems to be enough.
So this could be a fast to print lightweight design.

Simplify3d, Cura laden die Stapel-STLs nicht, aufgrund eines Fehlers in der Datei.

                                         |

It might be beneficial to add to the README to set the "Seam Position" in PrusaSlicer to rear. The default setting was "Aligned" if I'm not mistaken and that put the seam in direct skin contact in the final print and could cause discomfort.

edit: might cause more problems than it fixes, seam is on more critical structural part and may cause stress braking.

Hi,
it would be great if you could upload your used slicer profile to Github.
Best regards
Flo S

Hi there. I have a little bit modified STL and would like to print the file stacked like the stacked files that you provide. How did you create them? Just add the same model on top of another one in CAD with a small gap? How large of a gap? Did you try just importing a file multiple times into the slicer and positioning them vertically in the slicer?
Thanks in advance!