Shell script to install a Carebit Masternode on a Linux server running Ubuntu 16.04. Use it on your own risk.
wget -q https://raw.githubusercontent.com/zoldur/Carebit/master/carebit_install.sh
bash carebit_install.sh
After the MN is up and running, you need to configure the desktop wallet accordingly. Here are the steps:
- Open the Carebit Desktop Wallet.
- Go to RECEIVE and create a New Address: MN1
- Send 30000 CARE to MN1. You need to send all 30000 coins in one single transaction.
- Wait for 15 confirmations.
- Go to Help -> "Debug Window - Console"
- Type the following command: masternode outputs
- Go to Tools -> "Open Masternode Configuration File"
- Add the following entry:
Alias Address Privkey TxHash TxIndex
- Alias: MN1
- Address: VPS_IP:PORT
- Privkey: Masternode Private Key
- TxHash: First value from Step 6
- TxIndex: Second value from Step 6
- Save and close the file.
- Go to Masternode Tab. If you tab is not shown, please enable it from: Settings - Options - Wallet - Show Masternodes Tab
- Click Update status to see your node. If it is not shown, close the wallet and start it again. Make sure the wallet is un
- Select your MN and click Start Alias to start it.
- Alternatively, open Debug Console and type:
masternode start-alias MN1
- Login to your VPS and check your masternode status by running the following command. If you get Status 9, it means your masternode is active.
carebitcoin-cli masternode status
carebitcoin-cli mnsync status
carebitcoin-cli masternode status
carebitcoin-cli getinfo
Also, if you want to check/start/stop Carebit, run one of the following commands as root:
systemctl status Carebit #To check if Carebit service is running
systemctl start Carebit #To start Carebit service
systemctl stop Carebit #To stop Carebit service
systemctl is-enabled Carebit #To check if Carebit service is enabled on boot
Any donation is highly appreciated
BTC: 3MQLEcHXVvxpmwbB811qiC1c6g21ZKa7Jh
ETH: 0x26B9dDa0616FE0759273D651e77Fe7dd7751E01E
LTC: LNZpK4rCd1JVSB3rGKTAnTkudV9So9zexB