diyruz / geiger Goto Github PK

What to do in case device resets after some period of time?
Receives new "nwkAddr" everytime.

2 CTC-5 tubes

Hello! Could you add buzzer support? (Signal - BUZ. Contact 10 (P1.5) Е18МS)

Hi!

Is it possible to use different Zigbee module.
Instead of E18-MS1PA1-PCB to use E18-MS1PA2-PCB.

I know of differences between two of them but looks like every module sold now on Ali is PA2 - even if they list it as PA1.

Thank and really great job with this and all similar projects!!!!!!

Hello, it's a very nice project! Could you please add some instructions for setting this up in IDE, building and uploading? Thanks in advance.

On this firmware version and the latest version of the gateway firmware, no longer need to configure the parameters?

Only available in the state tab:
linkquality
radiation_dose_per_hour
radioactive_events_per_minute
trSeqNum

like in topic.
1.0.7 works properly

Hi,

On the schematic and BOM, the trim potentiometer is labelled as 200. Is this 200ohm or 200kilohm?

Many thanks!

Для проверки alert_threshold выставил в значение 12, Alert сработал и перешел из состояния OFF в ON, после я alert_threshold поправил на значение 20, но Alert теперь всегда в состоянии ON.
Решил что важен переход через "границу" значения - поставил в 13, уровень поднимался до 15-17, и после вернулся на 11-12 (перенес датчик из ванны в зал 🙂 ) , но Alert по прежнему ON.
Возможно я делаю что то не так, подскажите как правильно работать с alert_threshold и alert

Hi,
firmware 1.0.7 have bugs.
LED always ON
Radiation values to high and vary from 1000 to 50000.
You made new firmware from different branch. It made as absolutely new version?

suddenly values have strange results:

payload_raw: object
radioactive_events_per_minute: 44190
radiation_dose_per_hour: 24988064
linkquality: 86

Can you give a link for the capacitor c8 and c9, from what I can see these should be 10uf ceramic smd capacitors ?? volt.

https://www.aliexpress.com/item/1005003300558193.html?spm=a2g0o.store_pc_allProduct.8148356.5.4c601f46WlTg4b

Is this correct ?

Searching on Aliexpress for CAP-SMD_L3.2-W1.6-R-RD did not find anything

Thank you in advance.
Dirk