• Xilinx Vivado 2022.2
• cmake 3.0 or higher

Supported boards (out of the box)

• Xilinx VC709
• Xilinx VCU118
• Alpha Data ADM-PCIE-7V3

This repository uses git submodules, so do one of the following:

# When cloning:
git clone --recurse-submodules [email protected]/this/repo.git
# Later, if you forgot or when submodules have been updated:
git submodule update --init --recursive

1. Create a build directory

mkdir build
cd build

2. Configure build

cmake .. -DFNS_PLATFORM=xilinx_u55c_gen3x16_xdma_3_202210_1 -DFNS_DATA_WIDTH=64

All cmake options:

3. Build HLS IP cores and install them into IP repository

make ip

For an example project including the TCP/IP stack or the RoCEv2 stack with DMA to host memory checkout our Distributed Accelerator OS DavOS.

1. Setup build directory, e.g. for the TCP module

cd hls/toe
mkdir build
cd build
cmake .. -DFNS_PLATFORM=xilinx_u55c_gen3x16_xdma_3_202210_1 -DFNS_DATA_WIDTH=64

2. Run

make csim # C-Simulation (csim_design)
make synth # Synthesis (csynth_design)
make cosim # Co-Simulation (cosim_design)
make ip # Export IP (export_design)

All interfaces are using the AXI4-Stream protocol. For AXI4-Streams carrying network/data packets, we use the following definition in HLS:

template <int D>
struct net_axis {
	ap_uint<D>    data;
	ap_uint<D/8>  keep;
	ap_uint<1>    last;
};

To open a connection the destination IP address and TCP port have to provided through the s_axis_open_conn_req interface. The TCP stack provides an answer to this request through the m_axis_open_conn_rsp interface which provides the sessionID and a boolean indicating if the connection was openend successfully.

Interface definition in HLS:

struct ipTuple {
	ap_uint<32>	ip_address;
	ap_uint<16>	ip_port;
};
struct openStatus {
	ap_uint<16>	sessionID;
	bool		success;
};

void toe(...
	hls::stream<ipTuple>& openConnReq,
	hls::stream<openStatus>& openConnRsp,
	...);

To close a connection the sessionID has to be provided to the s_axis_close_conn_req interface. The TCP/IP stack does not provide a notification upon completion of this request, however it is guranteeed that the connection is closed eventually.

Interface definition in HLS:

hls::stream<ap_uint<16> >& closeConnReq,

To open a port to listen on (e.g. as a server), the port number has to be provided to s_axis_listen_port_req. The port number has to be in range of active ports: 0 - 32767. The TCP stack will respond through the m_axis_listen_port_rsp interface indicating if the port was set to the listen state succesfully.

Interface definition in HLS:

hls::stream<ap_uint<16> >& listenPortReq,
hls::stream<bool>& listenPortRsp,

The application using the TCP stack can receive notifications through the m_axis_notification interface. The notifications either indicate that new data is available or that a connection was closed.

Interface definition in HLS:

struct appNotification {
	ap_uint<16>			sessionID;
	ap_uint<16>			length;
	ap_uint<32>			ipAddress;
	ap_uint<16>			dstPort;
	bool				closed;
};

hls::stream<appNotification>& notification,

If data is available on a TCP/IP session, i.e. a notification was received. Then this data can be requested through the s_axis_rx_data_req interface. The data as well as the sessionID are then received through the m_axis_rx_data_rsp_metadata and m_axis_rx_data_rsp interface.

Interface definition in HLS:

struct appReadRequest {
	ap_uint<16> sessionID;
	ap_uint<16> length;
};

hls::stream<appReadRequest>& rxDataReq,
hls::stream<ap_uint<16> >& rxDataRspMeta,
hls::stream<net_axis<WIDTH> >& rxDataRsp,

Waveform of receiving a (data) notification, requesting data, and receiving the data:

When an application wants to transmit data on a TCP connection, it first has to check if enough buffer space is available. This check/request is done through the s_axis_tx_data_req_metadata interface. If the response through the m_axis_tx_data_rsp interface from the TCP stack is positive. The application can send the data through the s_axis_tx_data_req interface. If the response from the TCP stack is negative the application can retry by sending another request on the s_axis_tx_data_req_metadata interface.

Interface definition in HLS:

struct appTxMeta {
	ap_uint<16> sessionID;
	ap_uint<16> length;
};
struct appTxRsp {
	ap_uint<16> sessionID;
	ap_uint<16> length;
	ap_uint<30> remaining_space;
	ap_uint<2>  error;
};

hls::stream<appTxMeta>& txDataReqMeta,
hls::stream<appTxRsp>& txDataRsp,
hls::stream<net_axis<WIDTH> >& txDataReq,

Waveform of requesting a data transmit and transmitting the data.

Before any RDMA operations can be executed the Queue Pairs have to established out-of-band (e.g. over TCP/IP) by the hosts. The host can the load the QP into the RoCE stack through the s_axis_qp_interface and s_axis_qp_conn_interface interface.

Interface definition in HLS:

typedef enum {RESET, INIT, READY_RECV, READY_SEND, SQ_ERROR, ERROR} qpState;

struct qpContext {
	qpState		newState;
	ap_uint<24> qp_num;
	ap_uint<24> remote_psn;
	ap_uint<24> local_psn;
	ap_uint<16> r_key;
	ap_uint<48> virtual_address;
};
struct ifConnReq {
	ap_uint<16> qpn;
	ap_uint<24> remote_qpn;
	ap_uint<128> remote_ip_address;
	ap_uint<16> remote_udp_port;
};

hls::stream<qpContext>&	s_axis_qp_interface,
hls::stream<ifConnReq>&	s_axis_qp_conn_interface,

RDMA commands can be issued to RoCE stack through the s_axis_tx_meta interface. In case the commands transmits data. This data can be either originate from the host memory as specified by the local_vaddr or can originate from the application on the FPGA. In the latter case the local_vaddr is set to 0 and the data is provided through the s_axis_tx_data interface.

Interface definition in HLS:

typedef enum {APP_READ, APP_WRITE, APP_PART, APP_POINTER, APP_READ_CONSISTENT} appOpCode;

struct txMeta {
	appOpCode 	op_code;
	ap_uint<24> qpn;
	ap_uint<48> local_vaddr;
	ap_uint<48> remote_vaddr;
	ap_uint<32> length;
};
hls::stream<txMeta>& s_axis_tx_meta,
hls::stream<net_axis<WIDTH> >& s_axis_tx_data,

Waveform of issuing a RDMA read request:

Waveform of issuing an RDMA write request where data on the FPGA is transmitted:

• D. Sidler, G. Alonso, M. Blott, K. Karras et al., Scalable 10Gbps TCP/IP Stack Architecture for Reconfigurable Hardware, in FCCM’15, Paper, Slides

• D. Sidler, Z. Istvan, G. Alonso, Low-Latency TCP/IP Stack for Data Center Applications, in FPL'16, Paper

• D. Sidler, Z. Wang, M. Chiosa, A. Kulkarni, G. Alonso, StRoM: smart remote memory, in EuroSys'20, Paper

If you use the TCP/IP or RDMA stacks in your project please cite one of the following papers and/or link to the github project:

@inproceedings{DBLP:conf/fccm/SidlerABKVC15,
  author       = {David Sidler and
                  Gustavo Alonso and
                  Michaela Blott and
                  Kimon Karras and
                  Kees A. Vissers and
                  Raymond Carley},
  title        = {Scalable 10Gbps {TCP/IP} Stack Architecture for Reconfigurable Hardware},
  booktitle    = {23rd {IEEE} Annual International Symposium on Field-Programmable Custom
                  Computing Machines, {FCCM} 2015, Vancouver, BC, Canada, May 2-6, 2015},
  pages        = {36--43},
  publisher    = {{IEEE} Computer Society},
  year         = {2015},
  doi          = {10.1109/FCCM.2015.12}

@inproceedings{DBLP:conf/fpl/SidlerIA16,
  author       = {David Sidler and
                  Zsolt Istv{\'{a}}n and
                  Gustavo Alonso},
  title        = {Low-latency {TCP/IP} stack for data center applications},
  booktitle    = {26th International Conference on Field Programmable Logic and Applications,
                  {FPL} 2016, Lausanne, Switzerland, August 29 - September 2, 2016},
  pages        = {1--4},
  publisher    = {{IEEE}},
  year         = {2016},
  doi          = {10.1109/FPL.2016.7577319}
}

@inproceedings{DBLP:conf/eurosys/SidlerWCKA20,
  author       = {David Sidler and
                  Zeke Wang and
                  Monica Chiosa and
                  Amit Kulkarni and
                  Gustavo Alonso},
  title        = {StRoM: smart remote memory},
  booktitle    = {EuroSys '20: Fifteenth EuroSys Conference 2020, Heraklion, Greece,
                  April 27-30, 2020},
  pages        = {29:1--29:16},
  publisher    = {{ACM}},
  year         = {2020},
  doi          = {10.1145/3342195.3387519}
}

@PHDTHESIS{sidler2019innetworkdataprocessing,
	author = {Sidler, David},
	publisher = {ETH Zurich},
	year = {2019-09},
	copyright = {In Copyright - Non-Commercial Use Permitted},
	title = {In-Network Data Processing using FPGAs},
}

@INPROCEEDINGS{sidler2020strom,
	author = {Sidler, David and Wang, Zeke and Chiosa, Monica and Kulkarni, Amit and Alonso, Gustavo},
	booktitle = {Proceedings of the Fifteenth European Conference on Computer Systems},
	title = {StRoM: Smart Remote Memory},
	doi = {10.1145/3342195.3387519},
}

• David Sidler, Systems Group, ETH Zurich
• Monica Chiosa, Systems Group, ETH Zurich
• Fabio Maschi, Systems Group, ETH Zurich
• Zhenhao He, Systems Group, ETH Zurich
• Mario Ruiz, HPCN Group of UAM, Spain
• Kimon Karras, former Researcher at Xilinx Research, Dublin
• Lisa Liu, Xilinx Research, Dublin