Update Tasmota? about sonoff-tasmota HOT 10 CLOSED

Hi Kevin, Web interface savings ONLY work if the device is NOT in deepsleep. Should be clear. You can use the "wakeup pin" as described in the wiki to keep the device online. Then the web interface will work. After finishing you can bring it back to deepsleep.

from sonoff-tasmota.

from sonoff-tasmota.

Hi,

There is a lot of changes witch 2.4.1, new area for config is used and esp8266-wroom-02 module should be chosen, I will test it but I thing that should not be any problems with Wemos D1 with 18650. You should to use 2.4.0 esp release for Stefan mode in platformio.ini platform = [email protected] ; v2.4.0
for 2.4.1 Stefan mode will not work properly becayse of huge changes in 2.4.1

from sonoff-tasmota.

Updated to latest master release. @roblad: Will implement your changes on the Counterdevider asap. Maybe tomorrow. For the long term it should also work with 2.4.1. Let me know what I can change.

from sonoff-tasmota.

Thanks all.

Kevin

from sonoff-tasmota.

Hi,
@stefanbode, in my opinion the mosure sensor should be rewritten :-) as you can :-), I investigate with gay fro Sao Paulo the PEZM004 3phase- I let you know about results. Currently I have a problem with DS18x20 for 5 sensors it came and gone, one of them 2 or all. Sometimes I have 8 ???!!! doubled some of them. Andreas was not take care about it right now - I do not know what could be a reason, I ordered new DSes because old one have 3 years and after change I will investigate what is going on. I will test your updated mode today.

from sonoff-tasmota.

If you have more than 1 sensor the parasite power might not work because the current is too high to support all of them. You need to connect them to a stable 3.3V and Ground connection. 8x°C is a typical reply if the measurement was not successfully. I have similar problems with the LiIon 3.7V powered devices. If the battery is "end of life" you will also see this in wrong measures of the temperature.

from sonoff-tasmota.

Hi,

Even I use 1,5 k resistor betwen data and "+" now is better, but I think that conversion takes more time, but I changed resolution and it did not help, may be 5 V will solve the problem ? but I do not know if esp will not crash on the gpio. Do uou know any devider from 5 to 3.3 for DS ?

from sonoff-tasmota.

Should be no problem:

http://forum.arduino.cc/index.php?topic=233644.0

from sonoff-tasmota.

Hi,

I did 5v vdd and pull-up to 3.3v through 1k, looks better, but sometimes after reboot there is 1 lost, I will monitor

from sonoff-tasmota.