Module Configuration about sonoff-tasmota HOT 6 CLOSED

Hi Karl, I did not make a change hopefully in this section. Therefore it should behave like the original software. Please, can you confirm that it works with the original software and then attach two pictures to show the differences? I will try to fix it asap.

from sonoff-tasmota.

Sorry the drop down menu disappears when i try to make a screenshot.
But original software shows:

71 SerBr TX
72 SerBr Rx
75 SDM120 TX
76 SDM120 RX
77 SDM630 TX
78 SDM630 RX

Yours shows:

71 DeepSleep Switch
72
73
74
75

Hope you can find the reason!

It might get mixed up by your introduced entry "DeepSleep Switch"?

from sonoff-tasmota.

Nope. This SDM sensors came in in 6.0.0b or later. My fork is still 6.0.0a. That's the reason. I checked my latest sync from 26.6 and there is the SDM stuff still not there. That's my explanation. Please be patient for a new update

from sonoff-tasmota.

Upgraded to c version. Please be aware that I had to change (hopefully finally) the setoption parameters for interlock and the shutter. New ones are 81 and 80

from sonoff-tasmota.

That fine, i will be patient. But what are above mentioned
defines for in your software?

from sonoff-tasmota.

Please see the wiki. There is now support for blinds and shutters. This is a bit tricky because you need to deal with two relays in a smart way and need to do all calculation inside the firmware to ensure proper operation.

from sonoff-tasmota.