tasmota / autoconf Goto Github PK

The WS2812 / onboard LED doesn't work with GPIO8 as configured by "01Space_ESP32-C3-RGB"

Using GPIO7 instead as shown by the screenshot let the onboard LED working.

In Lilygo-S3-Display must be GPIO pin 15 HIGH if you use external power supply +5V (not USB-C). If GPIO 15 is down display is disconnected.

Sources:
T_Display_S3.pdf

The autoconf for Shelly Plus Plug IT is missing, and the one from Shelly Plus Plug S is not applicable.

Hello,
wed this guide to install Tasmota on a Shelly 10V: https://github.com/tasmota/mgos32-to-tasmota32
This also worked well. In step 8 I should select the 10V on the Autoconfig list, but it isn't there.

i use the mgos32-to-tasmota32-Plus10V.zip from Dec 31, 2023

what can i do ? Thanks for your time

We're pretty close though!

Getting this in the console when trying to migrate:

17:11:32.444 RSL: RESULT = {"OtaUrl":"http://ota.tasmota.com/tasmota32/release/tasmota32c3.bin"}
17:12:19.564 RSL: RESULT = {"OtaUrl":"http://ota.tasmota.com/tasmota32/release/tasmota32c3.bin"}
17:12:24.640 UPL: Step 1 Done
17:12:24.645 UPL: Starting step 2
17:12:24.726 UPL: flashing `safeboot` from http://ota.tasmota.com/tasmota32/release/tasmota32c3-safeboot.bin 712kB
17:12:24.727 UPL: error (internal_error) `app0` offset is not 0x10000
17:14:59.556 RSL: RESULT = {"OtaUrl":"http://ota.tasmota.com/tasmota32/release/tasmota32c3.bin"}
17:15:32.380 RSL: RESULT = {"OtaUrl":"http://ota.tasmota.com/tasmota32/release/tasmota32c3.bin"}
17:15:34.262 RSL: RESULT = {"OtaUrl":"http://ota.tasmota.com/tasmota32/release/tasmota32c3.bin"}

Tried to use pin 14 and 13 to drive relay. Figured out it actually controls the green led. Then after some more looking, realised the pins in the "configure module" and on the board don't match. On the board I see DIO8, 11 and 14 while in the module config I see GPIO 13,14 and 33.

Please advise if and how I can use custom pin.