[BUG] (support for runout sensor not working) about ender3v2s1 HOT 5 CLOSED

Same problem, the printer kept running even though the filament had run out.
I've checked the sensor and tried several settings in the filament menu without success.
It works with the original firmware.

from ender3v2s1.

The filament runout sensor is only checked when the extruder movement begins, and if the filament is missing, Marlin waits for "Runout Dist" before to launch an alert, of course the firmware only controls that if the print job was started from the SD.

from ender3v2s1.

I have also tried this.
When I start a print process from the SD card and no filament is loaded, the print process starts without a message.
I have already set Runout Dist down to 1mm, without success.

In the original Creality firmware, the print stops when the filament runs out and the print process cannot be started if no filament is loaded.

from ender3v2s1.

This issue has had no activity in the last 60 days. Please add a reply if you want to keep this issue active, otherwise it will be automatically closed within 10 days.

from ender3v2s1.

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.

from ender3v2s1.