Bed tramming Issue with Ender3v2-422-BLTouch-20220209 about ender3v2s1 HOT 11 CLOSED

Hi, do you have negative home offsets? Please, post all your offsets and dimensional settings.

from ender3v2s1.

Hi, thank you for your answer, here are the dimensional settings of my printer, do I need more information?

from ender3v2s1.

I have tried your settings and all the tramming points were reachable.

About this:

"the auto mesh seems to work, but when he finishes doing the automatic mesh of the whole tray before launching an impression, the pin of the bltouch remains deployed and rubs on the tray when moving and risks bending or breaking if it comes into contact with an obstacle"

When the auto mesh finishes the pin of the BLTouch must be stowed, if not, there is a problem of communication with your BLTouch. Please try disabling the HS mode.

from ender3v2s1.

I deactivated the HS mode, now during the automatic mesh when it arrives on the right the pin does not come out and it starts all the mesh again and repeats this without stopping.

tomorrow I will disassemble the bltouch and check all the wiring to see if there is not a bad contact somewhere

from ender3v2s1.

Don't forget to do a "Restore defaults" and "Store settings" to clear the EEPROM with the default values.

from ender3v2s1.

i have the same problem. with Ender3v2-422-BLTouch-2021112 it is working, with the latest firmware not.

from ender3v2s1.

i have the same problem. with Ender3v2-422-BLTouch-2021112 it is working, with the latest firmware not.

If you already do all the proposed tests then your BLTouch is not compatible with this version.

from ender3v2s1.

Hi, I checked the wiring and I don't see any problem there.

I also do the "Restore defaults" and "Store settings" but the problem persists

my BLtouch is a V3.1, I don't know if that's a compatibility problem

Would it be possible to send us the version of your marlin
"Ender3v2-422-BLTouch-2021112" please?

like that, while waiting for a more recent version that is compatible, we can continue to print with our printer, because with the old version it worked perfectly
Unfortunately I can't find it on github anymore.

from ender3v2s1.

I see posted here: https://www.facebook.com/groups/ender3v2firmware/posts/653009622407497/
Also try decreasing the probe z-feed rate

from ender3v2s1.

ok very good,
thank you very much

from ender3v2s1.

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.

from ender3v2s1.