Issue with bed tramming about ender3v2s1 HOT 7 CLOSED

I assume you had to change the X and Y offsets of your probe. If this is the case you also need to increase the probe margin. This is currently set to 20 mm. This means that if the offset you have set is bigger than then initial one then your nozzle is pushed very far right to an unreachable area. If your margin is set to 30mm then your nozzle will not be push than much to the right. I would suggest that you change the margin to 30 and test again. Let me know how it goes..

from ender3v2s1.

Which settings did you use jk? So probe settings and home offset?

from ender3v2s1.

see here guys
#15 (comment)

from ender3v2s1.

i have increasd the margin from 25 to 30 and now is it working

from ender3v2s1.

Which settings did you use jk? So probe settings and home offset?

I have the Satsana Air Duct which has these settings.

from ender3v2s1.

I assume you had to change the X and Y offsets of your probe. If this is the case you also need to increase the probe margin. This is currently set to 20 mm. This means that if the offset you have set is bigger than then initial one then your nozzle is pushed very far right to an unreachable area. If your margin is set to 30mm then your nozzle will not be push than much to the right. I would suggest that you change the margin to 30 and test again. Let me know how it goes..

This is the correct solution :)

from ender3v2s1.

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.

from ender3v2s1.